- Open the project "BF533_EZ_KIT_Video_Receive_C.dpj" in the VisualDSP Integrated Development Environment (IDDE). - Under the "Project" tab, select "Build Project" (program is then loaded automatically into DSP). - change switch #6 of SW3 to on of the ADSP-BF533 EZ-KIT Lite. - Connect a video NTSC/PAL CVBS signal to the video input jack AVIN1"at the bottom right" on the ADSP-BF533 EZ-KIT Lite. - Select "Run" from the "Debug" tab on the menu bar of VisualDSP. - Hit the stop button to halt the processor - Open the Image Viewer "View/Debug Window/Image Viewer". Do following steps: -- Type start address 0X1; Horizontal Pixels = 720; Vertical Pixels = 525; Pixels per bit = 8; Stride = 2 -- Image format = Gray Scale; Hit OK.You should see the image taken